Gateway 200ARC Network Manual page 72

Wireless Ethernet Networking
7
If you are connecting to an office Ethernet network and are required to
type a static IP address and subnet mask, ask your network system
administrator for the correct values.
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and a wireless access point router that automatically assigns IP
addresses to computers on the network, click
automatically
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and do not have a wireless access point router, use the IP address
and subnet mask provided by your cable or DSL provider as the address
for your computer. Each computer connected to your network will need
a unique, static IP address.
- OR -
If you are connecting to a home Ethernet network, do not have a cable
or DSL modem, and do not have a wireless access point router, click
the following IP address
a
b
8
Click
9
Click
10
Click
11
Repeat this procedure for every computer on your network.
12
After you enter the IP addresses on all your computers, go to
go from here" on page
66
.
, then type the following values.
Type the IP address in the
where N is any number between 1 and 254. We suggest 1 for the first
computer on your network, 2 for the next, and so on. The number
must be unique on your network.
Type the subnet mask in the
255.255.255.0 for all computers.
to close the Internet Protocol (TCP/IP) Properties dialog box.
OK
to close the Local Area Connection Properties dialog box.
OK
to close the Network Connections window.
X
70.
www.gateway.com
Obtain an IP address
box. Use the value 192.168.0.N
IP address
box. Use the value
Subnet mask
Use
"Where to