Setup 2 - EDAN SE-1200 Series User Manual

SE-1200 Series Electrocardiograph User Manual
2. For details of the ECG report printed by the USB printer, please
3. USB printing is ineffective in the auto periodic sampling mode,
4. Make sure that paper is installed in the USB printer before
Print Out Choose from: On or Off
(Only available Select On, the ECG report can be printed out by pressing the
PRINT/STOP key.
in the auto and
Select Off, the ECG report can be saved, but cannot be printed out by
rhythm modes)
pressing the PRINT/STOP key.
Speed Choose from: 5mm/s, 6.25mm/s, 10mm/s, 12.5mm/s, 25mm/s or
50mm/s
In the manual mode, select 5mm/s, 6.25mm/s, 10mm/s, 12.5mm/s,
25mm/s or 50mm/s.
Only 25mm/s and 50mm/s are available in the auto, rhythm and VCG
(only configurable for SE-1200 Express) modes.
Only 25mm/s is available in the R-R analysis mode.
Paper Marker Paper Marker is used to identify the start point of each page of the
recorder paper.
Choose from: Yes or No
Select Yes if the paper with black markers on the bottom is used, and the
device can identify the start point of each page of the recorder paper while
printing ECG reports.
Sample Time Choose from: 10s, 20s, 30s, 40s, 50, 60s
NOTE: If the time period is longer than 10s, the ECG data sampled

10.4.2 Setup 2

Press F2 to switch to the Setup 2 window.
refer to 6.5.2, "ECG Reports Printed by the USB Printer".
VCG mode,, manual mode and R-R analysis mode.
printing. Error may occur if no paper is loaded in the USB
Printer.
will be stored, and the specified part of data will be
analyzed.
- 89 -
System Setup