Chapter 8 Managing Orders; Loading Orders - EDAN SE-1200 Series User Manual

SE-1200 Series Electrocardiograph User Manual

Chapter 8 Managing Orders

NOTE: To use the order function, the ECG data management software (DMS) of the
manufacturer must be installed in the PC.

8.1 Loading Orders

Before loading orders, please configure the Order Setup screen. For details, please refer to
Section 8.5 "Setting Orders".
Operation procedures are as follows:
1. Connect the electrocardiograph to the PC installed with the DMS by using an Ethernet cable
recommended by the manufacturer.
2. Set Remote IP, Local IP, Gateway and Subnet Mask in the Transmission Setup window.
For details, please refer to Section 10.6 "Transmission Setup".
3. Select Load on the Order Manager screen to load orders from the DMS, and then a hint will
be displayed as follows.
NOTE: If orders are modified on the DMS, the corresponding orders displayed on
the Order Manager screen will be refreshed after you load orders from the
software.
4. If you select Exam.Room Filter on the Order Setup screen, orders will be filtered after you
press Load.
For details, please refer to Section 8.5 "Setting Orders".
5. If 200 orders already exist on the Order Manager screen, the following hint pops up after
you press Load.
- 69 -
Managing Orders