Table of Contents
Advertisement
7
Shortcut Operations
DCS code: 000N-777I total 1024 groups,
N is positive code, I is inverse code. Press
to to choose positive code or inverse
V/M
code.
4.
Press any key except
VOL+
Under channel mode,this operation can be temporarily used by
user. Once the radio is turned off or switched to another channel,
the temporary setting will be erased. If the channel setting
programmed for valid, the temporary setting will keep valid until
next change, turn off radio or switch to another channel, the
temporary setting will not changed.
Channel Scan
Repeatedly press
until LCD displays
DCT
14
TSQ. Press
to enter CTCSS scan mode,
SC/SKP
Once finding a mathcing CTCSS signaling, it
will stop for 15S then scan again. Press any
key exit.
DCS SCAN
Repeatedly press
until LCD displays
DCT
TSQ. Press
to enter CTCSS scan mode,
SC/SKP
Once finding a mathcing CTCSS signaling, it
will stop for 15S then scan again. Press any
key exit.
FM radio
Press to switch between FM radio and two
way radio mode.
/
or
key to exit scan.
VOL—
SC/SKP
In FM radio mode:
1.
Press
to switch between frequency mode and channel mode.
V/M
2.
Press
/
/
MHz
to page 11, Adjusting Frequency/Channel)
3.
Press
to start FM radio frequency or channel scan. (page 13,
SC/SKP
Frequency/Channel Scan)
4.
FUN
Press
and
to store or delete a channel. (Refer to page 12,
SET
V/M
Channel Edit/ Channel Delete)
5.
Press
or
to adjust volume level. (Refer to page 11,
VOL+
VOL—
Adjusting The Volume)
6.
In FM radio mode, you can setup resume method when radio receive
any valid radio singal)
A.
Press
, the LCD displays S, when
receiving valid radio signaling, the LCD
displays radio interface but the FM radio
still on.
B.
Press
, the S disappears from the LCD, when receving valid
radio signaling, the radio will exit FM radio mode and switch to
radio interface.
FM radio adjusting step size is 50Khz, and scan step size is
100Khz.
Power level control
FUN
Press
then press
to switch among
SET
FM/H·L
high , middle, low power level , the LCD
displays current power level.
Displays HI: transmit by high power level.
Displays MI: transmit by middle power level.
to change frequency or channels. (Refer
Hide quick links:
Advertisement
Table of Contents
