Roger Beep; Audio Signaling Call Setup; Editing Channel Name; Tx Off - AnyTone AT-778 User Manual

PL: Enable BTLO, transmitting is inhibited
when current channel receives a matching
carrier but dis-matching CTCSS/DCS.
press.
OFF:BCLO is disabled.It can transmit in any receiving status.
Default: OFF

Roger Beep

Enter No.05 function menu , the LCD displays "RB:OFF".
When release PTT to finish a calling, the radio will automatically transmit
a remind beep sound to the receiver. This fucntion can avoid
misunderstanding
when the caller pause speak but still hold PTT, and communciation will
not full transmitted when the receiver also press PTT.
1-8: group RB sound available.
OFF: Turn off RB function.
Default: OFF

Audio signaling call setup

Enter No.06 function menu , the LCD displays"CAL:OFF"
Hold PTT then press UP to transmit pre-programmed audio signaling, to
check if the receiver is near the radio. and not necessary to speak into
microphone to confirm.
1-8: group audio sound available.
OFF: Turn off RB function.
Default: OFF
Function Menu

Editing Channel NAME

Enter No.07 function menu , the LCD displays.
1.
Press or key to choose characater for present cursor
ocation.
2.
Press key to confirm and move to
V/M
next characater edit.
3.
Press to return to last characater edit.
DCT
In Frequency (VFO) mode ,this function will be auto-hidden.

TX OFF

Enter No.08 function menu , the LCD displays:
"TX:ON".
This function use to disable the transmitting
for current channel.
ON: TX allowed, press PTT to transmit.
OFF: TX not allowed, press PTT will emit a
wrong report.
Default: ON

Reverse TX/RX

Enter No.09 function menu , the LCD display "REV:OFF".
When turn of this function, the TX frequency
turns to RX frequency & RX frequency
changes to TX frequency. The signaling will
reversed if CTCSS/DCS signaling exited in
this channel.
8
17