Advertisement
Before You Begin
Before you begin building your Panic, make sure you read and understand all of the
instructions thoroughly.
Additionally, you will need to have the following items. Check to make sure that all of your
parts are there and in good shape, and review a couple quick building tips to make this
whole process go quicker and easier.
What You Will Need
•
Smooth and flat work surface
•
Wax paper to protect the plans
•
Thin Cyanoacrylate (CA) glue
•
Foam Safe Glue – 5 minute epoxy, white glue, or foam safe medium CA
•
Hobby knife with #11 blades
•
Needle nose pliers
•
Wire cutters
•
Sanding block with 200 grit sandpaper
•
2" packing tape or wing tape for covering the wings and fuselage
•
3M77 spray adhesive
•
4 channel radio minimum. If you use a 4 channel radio, you will need a Y cable for
the aileron servos.
•
4 channel receiver
•
~100+ watt brushless motor
•
4 micro servos (we recommend either the Hitec HS55s or the GWS Naros)
•
Electronic Speed Control (ESC) capable of handling at least 15 amps
•
3 cell LiPoly battery pack
Parts List
Quantity
Wood
1
1/64" Plywood for the battery mount and spar
1
1/32" Laser cut plywood sheet
1
1/16" Laser cut plywood sheet
Foam
2
Wing sections
2
Fuselage sections
5
Depron control surfaces
Additional Parts
1
1/8" round x 9" hardwood dowel
2
6" heat shrink tubing
1
6" Velcro strip for mounting the battery
2
1/32" x 18" thin music wire for the pushrods
12'
Plastic strapping
1
#2 x 3/8" motor retaining screw
2
Description of Part
Mountain Models Panic
Advertisement
