Table of Contents
Advertisement
Before You Begin
Before you begin building your Eva make sure you read and understand all of the
instructions thoroughly.
Additionally, you will need to have the following items. Check to make sure that all of
your parts are there and in good shape, and review a couple quick building tips to make
this whole process go quicker and easier.
What You Will Need
•
Smooth and flat work surface
•
Wax paper to protect the plans
•
Thin and thick Cyanoacrylate (CA) glue
•
Quick set epoxy
•
Hobby knife with #11 blades
•
Needle nose pliers
•
Wire cutters
•
Sanding block with 200 grit sandpaper
•
Covering material
•
Sealing iron for applying the covering
•
4 channel radio minimum
•
GWS EPS350C-C or Brushless Motor
•
2 aileron servos (we recommend either the Hitec HS55s or the GWS Picos)
•
2 tail servos (we recommend either the Hitec HS55s or the GWS Picos)
•
Electronic Speed Control (ESC) suitable for your motor
•
8 cell 650 mAH NiMH pack (for Brushed Motor)
•
3 cell 1200-1500 mAH LiPoly pack (for Brushless Motor)
Parts List
Number
in Kit
Loose Wood Plastic, and Carbon
2
1/4" x 1/4" x 18"Balsa triangle stock
1
1/4" x 1/4" x 4"Balsa triangle stock
1
5" x 3/16" hardwood dowel for elevator
1
0.23" x15" carbon spar tube
2
10.5" Yellow Pushrod Tubing
Metal
2
.025" x 18" " thin music wire for rudder and elevator pushrods
1
.032" x 18" " thin music wire for the tail wheel and pushrods
1
Aluminum Landing Gear
Plastic
1
Plastic Canopy
1
Plastic Nose Cowl
Description of Part
2
Advertisement
Table of Contents
