Mountain Models Panic Manual page 12

Addendum – Adding landing gear
While the Panic does not need gear, the kit comes with hardware to add it if you desire.
You will need to supply wheels that will fit on 3/32" axles.
Start by bending the 3/32" x 16" music wire as shown. The point in the image is the center
of the wire.
Glue the two sides to the landing gear base with CA or epoxy. Attach the wire to the base
with the wire ties.
Measure ¾" from the ends and make the final bend for the wheels. The wheels can be
retained by the internal star washers. The gear base is taped to the bottom of the fuselage
with the point of the wire facing back.
12 Mountain Models Panic