Advertisement
Before You Begin
Before you begin building your DL50 make sure you read and understand all of the
instructions thoroughly.
Additionally, you will need to have the following items. Check to make sure that all of your
parts are there and in good shape, and review a couple quick building tips to make this
whole process go quicker and easier.
What You Will Need
•
Smooth and flat work surface
•
Wax paper
•
Thin Cyanoacrylate (CA) glue
•
Foam Safe Glue – 5 minute epoxy or foam safe medium CA
•
Minwax water based Polycrylic
•
Hobby knife with #11 blades
•
Needle nose pliers
•
Wire cutters
•
Sanding block with 200 grit sandpaper
•
2 channel radio
•
2 channel receiver
•
2 micro servos
•
4 cell 350 mAH NiMH battery pack
Parts List
Number
in Kit
Wire and Carbon Rods
1
26.5" tapered carbon boom
4
.060" carbon spars
2
.025" music wire pushrods
2
Pushrod tubes
Foam, etc
2
Foam wing sections
2
.7 oz Fiberglass
1
1.4 oz Fiberglass
Bagged Parts
1
6" heat shrink tubing
1
6" Velcro strip for mounting the battery and receiver
1
1/16" x 3/8" x 2" Launch Peg
1
12" Kevlar tow
1
1/2" x 64" carbon tape
4
8-32 wing hold down screw
1
8-32 self tapping screw
2
Description of Part
Mountain Models DL50
Advertisement
