Table of Contents
Advertisement
Before You Begin
Before you begin building your Tantrum make sure you read and understand all of the
instructions thoroughly.
Additionally, you will need to have the following items. Check to make sure that all of
your parts are there and in good shape, and review a couple quick building tips to make
this whole process go quicker and easier.
What You Will Need
•
Smooth and flat work surface
•
Wax paper to protect the plans
•
Thin and thick Cyanoacrylate (CA) glue
•
Hobby knife with #11 blades
•
Needle nose pliers
•
Wire cutters
•
Sanding block with 200 grit sandpaper
•
90 ° triangle or small square to true the bulkheads and fuselage
•
Covering material
•
Sealing iron for applying the covering
•
Clear packing tape for hinges
•
5 channel computer radio with aileron/flap mixing, or a 4 channel radio with a Y
cable for the two aileron servos
•
4 or 5 channel receiver
•
GWS EPS300C-D motor with a 12x6 propeller
•
4 micro servos (we recommend either the Hitec HS55s or the GWS Picos)
•
Electronic Speed Control (ESC) capable of handling at least 10 amps
•
Battery pack (we recommend you use at least the following):
♦
8 cell 600 mAH NiCd (configured
♦
8 cell 950 mAH KAN NiMH (configured
Parts List
The following tables list all of the pieces that are in your Tantrum kit.
Description of Parts
Wood
Figure A: 1/8" laser cut balsa sheet
Mountain Models Tantrum
)
)
3
Advertisement
Table of Contents
