Temperature Setting - Fisher Scientific Fisherbrand Isotemp RT AVCD HPS Advanced Operation Manual

Temperature Setting

Temperature Setting
The temperature setting procedures are proceeded by using TEMP
button and the Heater Knob (left control knob).
Step 1: Press the TEMP Button and check the display showing the
current temperature setting.
Step 2: If you want to change the temperature setting, select the
desired temperature by turning and press the Heater Knob.
Step 3: Push the RUN/STOP Button.
Heater LED will be on and heater will be activated.
If the external temperature probe is connected, the temperature which
probe detects will be displayed. If not, top plate's temperature will be
displayed.
• Changing the temperature setting is allowed only within the low and
high temperature limits. If changing the temperature setting cannot
be done properly, check the low and high limits first. (Refer to Check
the Configuration Settings)
• You can set the low and high temperature limits at any value between
0° C and 350° C.
4-6
Section 4
Control Panel