Table of Contents
Advertisement
Isotempâ GP & FMS Refrigeration
Operation
Initial Startup
Temperature Control
Condensate Disposal
WARNING: DO NOT under any circumstances cut or
remove the third (ground) prong from the power cord. DO
NOT use a two-prong adapter plug.
Where a two-prong wall receptacle is encountered, it is the
personal responsibility and obligation of the user to have it
replaced with a properly grounded three-prong receptacle.
CAUTION: Do not use an extension cord. Use of an
ungrounded cord or an overloaded circuit VOIDS the
compressor warranty.
WARNING: If the unit is tilted in excess of 30
degrees, do not apply electrical power for a minimum of 12
hours.
Turn power on and verify that the condenser fan is running.
This model has a condenser fan located on the condensing
unit on top of the cabinet.
To adjust the interior temperature down, simply turn the
thermostat knob clockwise. For operation above an altitude
of 3000 ft., have the thermostat adjusted by a technician.
The condensate drain is at the center rear of the interior floor.
The condensate drain tube is connected to this drain and is
attached to the left front bottom of the unit behind the front
sheet metal. Unhook and place the drain tube into a suitable
pan and remove the drain plug. Turn the power to the unit to
the off position (O) and allow the unit to defrost.
4 of 8
Page
Advertisement
Table of Contents
