Cleaning And Maintenance; Cleaning Mineral Deposits - Heinner HEM-B2016SA Manual

www.heinner.com
VI. CLEANING AND MAINTENANCE
1. Cut off power source and let the coffee maker cool down completely before cleaning.
2. Clean housing of coffee maker with moisture-proof sponge often and clean water
tank, drip tray and removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the
housing in water for cleaning.
3. Detach the metal funnel by turning it anticlockwise, get rid of coffee residue inside,
then clean it with cleanser and in the end rinse it with clear water.
4. Clean all the attachments in the water and dry thoroughly.

CLEANING MINERAL DEPOSITS

1. To make sure your coffee maker operating efficiently, internal piping is cleanly and
the peak flavor of coffee, you should clean away the mineral deposits left every 2-3
months.
2. Fill the tank with water and descaler to the MAX level (the scale of water and
descaler is 4:1; the detail refers to the instruction of descaler. Please use "household
descaler", you can use the citric acid (obtainable from chemist's or drug stores)
instead of the descaler (the one hundred parts of water and three parts of citric acid).
3. According to the program of pre-heating, put the metal funnel (no coffee powder in
it) and carafe (jug) in place. Brewing water per "PRE-HEATING".
4. Press the ON/OFF switch to "1" position, the red lamp will be illuminated, press the
steam switch to the "0" position and the coffee/hot water selector to the "1"
position, when there is water flowing out and close the pump（the coffee/hot water
selector to the "0" position, and waiting for a moment, the coffee maker begins to
be heated.
5. When the green lamp is illuminated, it shows the heating is finish. Pressing the
coffee/hot water selector to the "1" position and make make two cups coffee
(about 60ml). Then close the pump（the coffee/hot water selector to the "0"
position）and wait for 5s.
6. Press the steam switch to the "1" position, waiting for until the green indicator is
illuminated. Make steam for 2min, then turn the steam control knob to "OFF" or "0"
position to stop making steam. Press the steam switch to the "0" position to stop the
unit immediately; make the descalers deposit in the unit at least 15 minutes.
7. Restart the unit and repeat the steps of 4-6 at least 3 times.
8. Then Press the ON/OFF switch to "1" position, when the green lamp is illuminated,
press the coffee/hot water selector to the "1" position to brew until no descaler is
left.
9. Then brewing coffee (no coffee powder) with tap water in the MAX level, repeat the
steps of 4-6 for 3 times (it is not necessary to wait for 15 minutes in step of 6), then
brewing until no water is left in the tank.
10. Repeat the step 9 at least 3 times to make sure the pipe is clean.
850W, 50Hz, 220-240V
5