Making Hot Water - Heinner HEM-B2016SA Manual

www.heinner.com


MAKING HOT WATER

1. With this function, you can pre-heat your coffee cup to ensure that the temperature of
the coffee will not decrease. So as to improve the coffee flavor.
2. Clean your coffee cup. After drinking coffee, you can directly make hot water with this
coffee maker to clean the cups. This makes it more simple and convenient to clean the
cups.
Methods:
1. Press the On/Off switch to the "1" position; the Steam switch to "0" position, Coffee/hot
water selector to "0" position. The red lamp will be illuminated; after a moment, the
green lamp will be illuminated.
2. First, turn the steam control knob from "OFF" to "0" position in anti-clockwise. (Turn the
knob to at least 135 degree.) Then press coffee/hot water selector to "1" position, and
hot water will flow out from the steam wand.
Note: At first, the hot water will scatter from the steam wand. May let the steam
wand outlet close to the coffee cup wall. Thus at this moment, you need to pay
attention to the protection of hot water splash because it may burn skin.

PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like
drinking chocolate, water or tea.
Method:
1. Open the tank cover, remove the detachable tank and fill it with desired water, the water
level should not exceed the "MAX" mark in the tank. Then place the tank into the
appliance properly.
2. Replace the tank and then connect the appliance to power supply source.
3. Press the ON/OFF switch to the "1" position, the red lamp is illuminated.
4. Turn the steam control knob to "OFF" or "0" position， make the coffee/hot water
selector on the "1" position, the pump will flow water, when there is water flowing out,
close the pump (coffee/hot water selector to the "0" position) immediately, pressing
the steam selector to the "1" position and waiting for a moment, the appliance begins to
be heated until the green lamp is illuminated, it shows the heating is finish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the steam control knob in
anti-clockwise slowly to start making steam.
7. When the required temperature is reached, you can turn the steam control knob to
"OFF" or "0" position.
8. Press the ON/OFF switch to the "0" position to cut the power source off.
850W, 50Hz, 220-240V
4