Making Espresso - Heinner HEM-1050XMC Instruction Manual

www.heinner.com 1050W, 50Hz, 220‐240V
3. Place an espresso cup (your cup) on removable cup shelf.
4. Then connect the appliance to power source. Make sure the operation knob is on
the "O" position.
5. Press down the ON/OFF button to the lower position which is the " " position.
The red indicator will be illuminated.
6. The appliance will start heating.
7. Press down the Coffee/steam button to the higher position which is the
"
" position, waiting for a moment, until the ready indicator lights, it shows the
pre‐heating is finished.

MAKING ESPRESSO

1. Remove the metal funnel by turning it in clockwise, set steel mesh into metal funnel.
Add coffee powder to steel mesh with measuring spoon, a spoon of coffee powder
can make about a cup of top‐grade coffee, then press the ground coffee powder
tightly with the tamper.
2. Then insert the funnel into the appliance from the "INSERT" position and release
the press bar, and you can fix them into coffee maker firmly by turning it anticlockwise
until it is at the "LOCK" position.
3. Pour out the hot water in the cup. Then place the hot cup (your cup) on removable
cup shelf.
4. At the time, the ready indicator is illuminated, turn the operation knob to the "
" position. The coffee will flow out.
Note: During brewing coffee or making steam, it is normal that the green indicator is
likely to extinguish, it only means that the heater is heating up to keep the
temperature at the standard range.
5. You should turn the operation knob to the "O" position when desired coffee is
obtained or the colour of coffee changes weak obviously, then press the power switch
to the higher switch, the power indicator and ready indicator go out and the coffee
maker stops working, your coffee is ready now.
WARNING: Do not leave the coffee maker unattended during making the coffee, as
you need operate manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out by turning it
clockwise, then pour the coffee residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
16