Filling The Water Reservoir - Heinner HEM-DL1470BK Instruction Manual

www.heinner.com
THE GRIND
This is a vital step in the espresso making process if you are grinding your own coffee and
takes practice. The coffee must be of a fine grind. The correct grind should look like salt.
If the grind is too fine, the water will not flow through the coffee even under pressure. These
grinds look like powder and feel like flour when rubbed between fingers.
If the grind is too coarse, the water flows through the coffee too fast, preventing a
full-flavored extraction. Be sure to use a quality grinder for uniform consistency.
OPERATING INSTRUCTIONS

FILLING THE WATER RESERVOIR

a. Fill the reservoir with water, you may either use a jar to fill it up or remove it from the
unit or then fill it up under the tap. If you have removed it from the unit to fill up with
water, please make sure to place it back tightly in its place. Fill the reservoir with the
desired amount of water ensuring it ranges within the"MIN" and "MAX" markings on the
tank. Never use warm or hot water to fill the water reservoir.
b. Close the water reservoir lid and place it back in the unit ensuring it fits tightly.
FILLING THE MILK RESERVOIR
If you plan to prepare cappuccino or latte, remove the milk reservoir from the unit and open
the lid then pour the quantity of cold milk you estimate you will need between the "MIN"
and"MAX" levels. When done, place the milk reservoir back in the unit ensuring it fits tightly.
Note: You can use the type of milk of your preference, i.e. whole milk, low fat milk, organic or
soy milk.
CHOOSE THE FILTER
Select the filter to be used as follows:
A. FOR A SINGLE SHOT– use the filter for a single shot of espresso if using ground coffee.
B. FOR A DOUBLE SHOT OR TWO SINGLE SHOTS - use filter for a double shot.
1230-1470W, 50Hz, 220-240V
NOTE: The pod filter included with your
unit has been designed to work only with
45mm pods.
27