NEC BladeServer Express5800 Series User Manual page 16

1-2 Notes on Using Your Server
SAFETY NOTES
This section provides notes on using the server safely. Read this section carefully to ensure proper
and safe use of the server. For symbols, see "SAFETY INDICATIONS" provided earlier.
Do not use the server for services where critical high availability may directly
affect human lives.
The server is not intended to be used with or control facilities or devices
concerning human lives, including medical devices, nuclear facilities and
devices, aeronautics and space devices, transportation facilities and devices;
and facilities and devices requiring high reliability. NEC assumes no liability
for any accident resulting in personal injury, death, or property damage if the
server has been used in the above conditions.
Do not disassemble, repair, or alter the server.
Never attempt to disassemble, repair, or alter the server on any occasion
other than described in this User's Guide. Failure to follow this instruction
may cause an electric shock or fire as well as malfunctions of the server.
Do not remove the lithium battery.
The server contains a lithium battery. Do not remove the battery. Placing the
battery near a flame or in water may cause an explosion.
When the server does not operate properly due to a dead lithium battery,
contact your service representative. Do not disassemble the server to
replace or recharge the battery yourself.
Do not use the server if any smoke, odor, or noise is present.
If smoke, odor, or noise is present, immediately turn off the system and
disconnect the power plug from the outlet, then contact your service
representative. Using the server in such conditions may cause a fire.
Keep needles or metal objects away from the server.
Do not insert needles or metal objects into ventilation holes in the server.
Doing so may cause an electric shock.
Use the devices only in the specified areas.
CPU blades and hard disk drives should be installed in a dedicated Blade
Enclosure. Do not install CPU blades and hard disk drives in a chassis other
than a Blade Enclosure. Failure to do so may result in fire and/or electric
shock.
WARNING