NEC BladeServer Express5800 Series User Manual page 180

9-18 Upgrading Your Server
Removal
Remove the DIMM in the following procedure:
NOTE:
appearing in POST or NEC ESMPRO to confirm the CPU blade where
the DIMM is installed.
1.
Shutdown the CPU blade and turn off the power o.
2.
Remove the CPU blade from the Blade Enclosure.
Refer to the User's Guide of the Blade Enclosure.
3.
Place the CPU blade on an anti-static sheet.
4.
Remove the two screws securing the rear cover.
5.
Firmly hold the cover, move it slightly toward the rear of the CPU blade, and then lift the
cover to remove it.
6.
Remove the four screws securing the front cover.
7.
Firmly hold the front cover and lift it straight up to remove it from the CPU blade.
8.
Open the levers at both ends of the DIMM socket and remove the DIMM.
9.
Repeat the above steps to remove another DIMM.
10.
Install a new DIMM.
11.
Replace the covers and install the CPU blade in the Blade Enclosure.
12.
Power on the CPU blade. Make sure that no error messages appear in POST.
If an error message appears, write down the message and see the error message list in
Chapter 8.
If the CPU blade does not start, the DIMM may not be installed in the socket correctly.
Reinstall the DIMM.
13.
In the BIOS Setup utility, select [Advanced] – [Memory Configuration] – [Memory
Retest] and set [Memory Retest] to [Yes] to clear the error information (see Chapter 4).
14.
Set [Advanced] – [Reset Configuration Data] to [Yes].
This is required to update the hardware configuration information. See Chapter 4 for
details.
15.
Set the paging file size to a value larger than the recommended value (installed memory *
1.5) for Windows.
To remove the defective DIMM, check the error message