English
EN
Two short beeps indicate that the USB is connected. ' ' is shown on the
■
display of the blood pressure monitor while the Veroval
connected to the PC by the USB cable.
Start the data transfer using the 'medi.connect' software.
■
If the data transfer was not successful, you will be informed of this by the
■
Veroval
medi.connect software. In that case, remove the connection to the
®
PC and start the data transfer again.
The automatic switch-off function of the blood pressure monitor is deactivated
■
while the monitor is connected to the PC by USB. To protect the battery life
the USB cable should therefore not remain inserted.
A longer beep indicates that the USB is disconnected from the device. The
■
blood pressure monitor then switches itself off automatically.
IFU_Veroval_dc_SK2_0307661_EN_TR_AE_CN_200918.indd 28
®
28
duo control is
17.10.18 18:03