Removing And Transporting The Display - SMART Board 6000S Series Installation And Maintenance Manual

Chapter 4 Maintaining the display
Note
For pen and eraser part numbers, refer to the service parts diagrams.

Removing and transporting the display

On occasion, you might need to remove the display from its current wall mount and transport it to
another location.
To remove the display safely, use two or more trained installers.
Warning
Do not attempt to move the display by yourself. The display is very heavy.
l
Do not move the display by connecting a rope or wire to the handles on the back. The display can
l
fall and cause injury and product damage.
Important
Follow the documentation included with any third-party mounting hardware.
To remove the display
1. Turn off any connected computers.
2. Turn off the display (see Turning off, turning on, and resetting the display on page 45).
3. Flick the switch beside the AC power inlet to the OFF (O) position.
4. Remove all accessible cables and connectors.
5. Remove any modules from the accessory slot.
6. Lift the display from its mounting location.
Warning
Do not place the display on a sloping or unstable cart, stand or table. The display could fall,
resulting in injury and severe product damage.
Caution
Do not leave the display face up, face down or upside down for an extended period. This could
cause permanent damage to the screen.
7. Remove the mounting brackets.
smarttech.com/kb/171414 49