SMART Board 6000S Series Installation And Maintenance Manual page 4

Contents
Disconnect the display's power cable from the wall outlet and seek assistance from qualified
l
service personnel if any of the following occur:
o The power cable or plug is damaged
o Liquid is spilled into the display
o Objects fall into the display
o The display is dropped
o Structural damage, such as cracking, occurs
The display behaves unexpectedly when you follow operating instructions
o
Caution
Turn off the display before cleaning its screen. Otherwise, you may scramble the desktop icons or
l
inadvertently activate applications when you wipe the screen.
Avoid setting up and using the display in an area with excessive levels of dust, humidity, and
l
smoke.
Make sure an electrical socket is near the display and remains easily accessible during use.
l
In Europe, the display should be used only with European TN and TT power distribution systems.
l
It is not suitable for older, IT-type power distribution systems found in some European countries.
"This system (IT-type) is widely used isolated from earth, in some installations in France, with
impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral not distributed, at
230V line-to-line."
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing the display.
The accessory slot's maximum available power is 60 W. The slot is not a limited power source. To
l
reduce the risk of fire, make sure that accessories connecting to the slot satisfy the fire enclosure
requirements of IEC 60950-1 and IEC 62368-1.
You must connect the USB cable that came with the display to a computer that has a USB
l
compliant interface and that bears the USB logo. In addition, the USB source computer must be
compliant with IEC 60950-1 and/or IEC 62368-1. It must be certified by UL or CSA or another NRTL
/ SCC certified body to CSA/UL 60950-1 or CSA/UL 62368-1 and it must have the CE marking. This
is for operating safety and to avoid damage to the display.
Wait five minutes before removing accessories from the display's OPS slot to allow the accessory
l
to cool.
smarttech.com/kb/171414 4