Cleaning And Maintaining Hardware; Checking The Display Installation; Cleaning The Screen - SMART Board 6000S Series Installation And Maintenance Manual

Chapter 4 Maintaining the display
3. Flick the switch beside the AC power inlet to the OFF (O) position.
Note
Wait at least 30 seconds before turning the display back on.
To turn the display back on
1. Flick the switch beside the AC power inlet to the ON (I) position.
2. Press the Power button
To reset the display
Press and hold the Power button
Note
Resetting the display does not change any user settings or delete saved files.
The display resets.

Cleaning and maintaining hardware

Checking the display installation

Inspect the display installation frequently to ensure that the display remains securely installed.
Check the mounting location for signs of damage or weakness that can occur over time.
l
Check for loose screws, gaps, distortions, or other issues that could occur with the mounting
l
hardware.
If you find an issue, contact a trained installer.

Cleaning the screen

Follow these instructions to clean the screen without damaging its anti-glare coating or other product
components.
Caution
Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used on the
l
screen, remove the ink as soon as possible with a lint-free, non-abrasive cloth.
Do not rub the screen with dense or rough material.
l
smarttech.com/kb/171414
on the convenience panel or the remote control.
on the convenience panel or the remote control for 10 seconds.
46