SMART Board 6000S Series Installation And Maintenance Manual page 34

Chapter 3 Connecting computers and other devices
Note
Install SMART software on computers you connect to the display (see Installing SMART software
l
on page 31).
You can charge devices connected to the USB Type-C receptacles. SMART Board 6000S (V3)
l
models can provide up to 65 W to connected devices (the USB Type-C receptacle labeled USB-C
2 on the rear connector panel provides 30 W when an OPS PC module is installed). The USB
Type-C receptacle on SMART Board 6000S (C) models can provide up to 60 W.
Viewing a connected computer's input
Use the Input app to view a connected computer's input on the display.
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap Input on the Home screen.
OR
Press Input on the remote control.
The display shows thumbnails of the devices that are connected to the display:
A grey thumbnail indicates no device is connected to an input.
o
o A black thumbnail indicates a device is connected to an input but is in Sleep mode.
o A thumbnail showing a preview screen indicates an active device is connected to an input.
Tip
If iQ is disabled and you want a computer's input to appear whenever you wake up the display,
tap the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.
Setting a connected computer's resolution and refresh rate
This table presents the recommend resolutions and refresh rates for the display's inputs:
Input source
HDMI 1
smarttech.com/kb/171414
If iQ is disabled
Press the Home button
Resolution
3840 × 2160
or the Input button
on the remote control.
Refresh rate
60 Hz
34