Chapter 4
Maintaining the display
2. Flick the power switch (beside the AC power inlet) on the rear bottom of the panel to the OFF (O)
position.
SBID-GX165
To turn the display on
1. Flick the power switch (beside the AC power inlet) on the rear bottom of the panel to the ON (I)
position.
2. Press the Power button
To turn the display on or off (with an OPS module installed)
If OPS is currently set as the Boot input Source input source (see Source settings on page 83), the OPS
l
module will start automatically when the display is turned on.
Before turning off the display, turn off the OPS module using the power controls on the OPS module
l
(such as the Shut down command in the Windows 10 start menu on the OPS).
When the OPS module is turned off, it is then safe to turn off the display using the steps listed above in
l
To turn the display off.
Cleaning and maintaining the display
Checking the display installation
Inspect the display installation frequently to ensure that the display remains securely installed.
Check the mounting location for signs of damage or weakness that can occur over time.
l
Check for loose screws, gaps, distortions, or other issues that could occur with the mounting hardware.
l
smarttech.com/kb/171744
on the front control panel or the remote control for five seconds.
SBID-GX175 and SBID-GX186
54