Xerox WorkCentre 3215 Service Manual page 119

Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the parts to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
NOTE: The Frame is flexible and can be bowed out if the screws are not tightened in the cor-
rect order.
Reinstall the Frame as follows so it seats flush against the printer's internal modules.
1. After aligning the left and right frames together with the inside modules; install, but do not
tighten, the Paper Path Frame screws, (3) on the Left and Right Side Frame to hold the
printer together.
Refer to (Figure 14) and (Figure 15).
2. On the bottom of the printer, refer to
a. Install the ground screw (1).
b. Connect the Printer Drive Motor Connector.
3. Tighten the Paper Path Frame screws installed in Step 1.
4. Continue with the parts replacement.
a. When installing the Paper Feed Sensor Actuator made sure the spring is seated in
the frame cutout, refer to (Figure
b. Refer to Figure 20 for installation of the Feed and Registration Drive Gears, and
Snap Ring.
Snap Ring
Figure 20 Feed and Registration Drive Gears
Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
(Figure 8):
7).
c. When installing the Front Cover Support Arm, ensure that it is placed correctly on
the Stop Bracket (Figure
Support Arm
Figure 21 Front Cover Support Arm Placement
June 2014
4-55
21).
REP 1.34, REP 1.35
Repairs