Xerox WorkCentre 3215 Service Manual page 112

6. Remove the Main Drive Unit (5 screws) and move the Fuser Drive Locking Lever to the
Unlock position (Right) (Figure 2).
Screws
Locking Lever
Figure 2 Main Drive Unit
7. Perform the Following (Figure 3):
a. Disconnect the Feeder PWB Connector (CN3), and remove the PWB (1 screw).
b. Remove the Feed and Registration Clutches, remove the Snap Rings and Washer
from the Clutches.
c. Remove the Feed and Registration Clutch Assembly and the PWB, release the
latches (2).
Repairs
REP 1.34
CN3
Snap Rings
& Washers
Figure 3 Feed and Registration Clutch / Feeder PWB
8. Remove the Feed and Registration Clutch Drive Gears
Figure 4 Feed and Registration Clutch Drive Gears
June 2014
4-48 Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
Screw
Latches
(Figure 4).
Clutch Drive
Gears