Rep 1.29 Exit Roll And Bushings; Rep 1.30 Feed Idler Gear - Xerox WorkCentre 3215 Service Manual

REP 1.29 Exit Roll and Bushings

Parts List on PL 4.3
Removal
1. Switch Off the Printer and unplug the Power Cord.
2. Remove the Middle Cover (REP 1.3).
3. Remove the Exit Roll and Bushings
a. Remove the Drive Gear, release the latch.
b. Remove the Bushings (2), release the latch and rotate the bushing.
c. Remove the Exit Roll.
Bushings
Drive Gear
Figure 1 Exit Roll and Bushing (Top View)
Replacement
Install the components in the reverse of removal.
Repairs
REP 1.30
(Figure 1).
Exit Roll

REP 1.30 Feed Idler Gear

Parts List on PL 4.6
Removal
1. Switch Off the Printer and disconnect the Power Cord.
2. Remove the Left Side Cover
3. Remove the Feed Clutch and Drive Gear
a. Remove the E-ring and Washer from the Feeder Clutch.
b. Remove the Feeder Clutch and Drive Gear.
Feed Clutch
Figure 1 Feed Clutch Removal
June 2014
4-40 Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
(REP 1.2).
(Figure 1):