System; Init; Commissioning - INTEGRA Metering CALEC ST III User Manual

Operation
Display
dtc
6.6.20

System

Display
FNr
SYS
DAT
RW
FW
HW
CS
6.6.21

Init

One-time on-site setting of the calibration-relevant input values "IMP EBS"
Assure that with the selected unit the accumulative energy amount can be handled without counter
u
overflow.
This mode can be set once on site (activation by zeroing the pulse value).
Display
Init
Go
6.7

Commissioning

Depending on the required data output and the installed communication modules, a number of parameters
have to be set.
The adjustable values are assigned to three safety levels:
Safety level
User mode
Service mode
Programming
mode
Select the service mode [}p. 40].
u
Select the menu for the required data output [}p. 39].
u
Set the required parameters [}p. 39].
u
3-140-UM-EN-02
Meaning
Automatic sensor adjust-
ment
Meaning
Serial number
Calculator function
Manufacturing date
Firmware version of calcula-
tor
Firmware version of main
board
Hardware version
Checksum of firmware
Meaning
Allows the one-time setting
of the values ImP / Sid / Eu /
Ed / V during commissioning
on site
Confirms the one-time set-
ting at commissioning
Access
When the housing is closed the freely accessible data can be
displayed by using the keys.
Can be activated with the service key while the cover is open.
Allows the setting of all parameters that are not required to
be calibrated for commissioning and the display of all set-
tings.
Complete parameterization, including calibration-relevant
values. Can only be activated by destroying the calibration
seal. Not described in this manual.
Visible
Yes
Visible
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Visible
Editable only in edit mode
Editable only in edit mode
Editable
Programming mode
Editable
No
No
No
No
No
No
No
Editable
Init
Go
Level Code
1111
3132
47 / 56