Endress+Hauser HART Flowmeter Proline 400 Brief Operating Instructions page 44

Operation options
Computer settings
Settings
User rights
Proxy server settings of the Web
browser
JavaScript
Network connections
In the event of connection problems:
Measuring device: Via CDI-RJ45 service interface
Device
Measuring device
Web server
Measuring device: via WLAN interface
Device
Measuring device
Web server
6.3.3 Establishing a connection
Via service interface (CDI-RJ45)
Preparing the measuring device
Configuring the Internet protocol of the computer
The following information refers to the default Ethernet settings of the device.
IP address of the device: 192.168.1.212 (factory setting)
1. Switch on the measuring device.
2. Connect to the computer using a cable .
44
Interface
CDI-RJ45
Appropriate user rights (e.g. administrator rights) for TCP/IP and proxy server
settings are necessary (for adjusting the IP address, subnet mask etc.).
The Web browser setting Use a Proxy Server for Your LAN must be deselected .
JavaScript must be enabled.

If JavaScript cannot be enabled:
enter http://192.168.1.212/basic.html in the address line of the Web
browser. A fully functional but simplified version of the operating menu
structure starts in the Web browser.
Only the active network connections to the measuring device should be used.
Switch off all other network
connections such as WLAN.
CDI-RJ45 service interface
The measuring device has an RJ45 interface.
Web server must be enabled; factory setting: ON
WLAN interface
The measuring device has a WLAN antenna:
Transmitter with integrated WLAN antenna
Web server and WLAN must be enabled; factory setting: ON
Flowmeter Proline 400
WLAN
Switch off all other network
connections.
Endress+Hauser