Install Impeller - Ariens Sno-Thro Deluxe Series Service Manual

Install Impeller

See Figure 68.
1. Apply a thin layer of anti-seize compound to impeller
shaft.
2. Secure impeller to impeller shaft with two roll pins.
3. Reinstall auger assembly into housing and seat
impeller shaft in ball bearing at housing rear. See
Figure 60.
4. Secure support bushings to auger housing with six
tapping screws. See Figure 69.
Figure 68
Figure 69
See Figure 70.
5. Tighten three hex nuts securing bearing plate to
housing.
6. Apply a thin layer of anti-seize compound to impeller
shaft end.
7. Reinstall spacer bushing onto impeller shaft.
8. Reinstall attachment drive pulley onto impeller shaft
and secure with locking washer and hex bolt. Torque
to 7.9 N•m – 16.5 N•m (5.8 lb-ft – 12.2 lb-ft).
2
1
1. Spacer Bushing
2. Bearing Plate
9. Reinstall auger housing to frame. See Reinstall Auger
Housing on page 10.
10. Reconnect spark plug wire.
EN – 31
Figure 70