Traction Drive Cable Replacement; Remove Traction Drive Clutch Cable - Ariens Sno-Thro Deluxe Series Service Manual

TRACTION DRIVE CABLE
REPLACEMENT

Remove Traction Drive Clutch Cable

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Loosen traction drive clutch cable.
4. Under control panel, remove hairpin, flat washer and
spring retaining upper traction clutch cable to clutch
lever pin and disconnect cable. See Figure 79.
Figure 79
See Figure 80.
5. Disconnect lower traction drive cable from upper
traction drive cable.
6. Loosen, but DO NOT remove shoulder bolt retaining
cable pulley to cable pulley bracket.
7. Remove belt cover. See Figure 6.
EN – 36
Figure 80