Gearcase Rebuild; Disassemble Gearcase - Ariens Sno-Thro Deluxe Series Service Manual

GEARCASE REBUILD

Disassemble Gearcase

IMPORTANT: Save all parts for reassembly, unless
otherwise specified.
1. Remove gearcase. See Remove Gearcase Assembly
on page 29.
2. Remove any rust, if present, from auger and impeller
shafts with sandpaper. Wipe clean with oil.
3. Remove drain plug and seal washer from gearcase.
See Figure 126.
Figure 126
See Figure 127.
4. Remove hardware retaining gearcase cover and
remove cover.
5. Remove gasket and drain gearcase.
6. Remove bushing retainer from gearcase. See
Figure 128.
EN – 54
Figure 127
Figure 128