Install Swing Gate Assembly - Ariens Sno-Thro Deluxe Series Service Manual

12. Remove two hair pins retaining swing gate assembly
to swing gate pivot pin and remove pin. See Figure 47.
WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
13. Disengage traction drive belt from traction drive pulley
and remove swing gate assembly. See Figure 48.
Figure 47
Figure 48

Install Swing Gate Assembly

WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
1. Position swing gate assembly inside frame.
2. Reinstall traction drive belt on traction drive pulley.
3. Reinstall pivot rod through swing gate and secure in
tractor frame with flat steel washer and hairpin. See
Figure 49.
EN – 24
Figure 49