Install Friction Disc - Ariens Sno-Thro Deluxe Series Service Manual

Install Friction Disc

1. Align friction disc assembly with shift fork roller
bearing and hex shaft. See Figure 38.
2. Insert hex shaft through friction disc, pinion sprocket
and right side of frame. See Figure 39.
Figure 38
Figure 39
See Figure 40.
3. Reinstall bearing onto hex shaft end.
4. Reinstall bearing flange over bearing and secure to
frame with three tapping screws.
5. Reinstall spring clips into hex shaft.
6. Reinstall adjustment pin onto shift arm and secure
with hairpin.
7. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
8. Reinstall wheels onto axle and secure with snap clips.
9. Return unit to operating position.
10. Fill fuel tank and reconnect spark plug wire.
11. Adjust speed selector lever. Refer to Operator's
Manual for adjustment procedure.
IMPORTANT: Check all adjustments after first use.
EN – 21
Figure 40