Install Traction Drive Idler Assembly - Ariens Sno-Thro Deluxe Series Service Manual

See Figure 24.
4. Disconnect tension spring from traction drive idler
arm.
5. Remove roll pin. Remove attachment idler arm hub
from drive idler pivot rod.
6. Remove torsion spring from idler pivot rod.
7. Remove traction idler arm assembly from pivot rod.
See Figure 25.
Figure 24
Figure 25

Install Traction Drive Idler Assembly

See Figure 26.
1. Reinstall traction drive idler assembly and torsion
spring onto idler pivot rod.
2. Reinstall attachment idler arm hub onto idler pivot rod.
See Figure 27.
3. Align attachment arm idler hub with hole through pivot
rod and reinstall roll pin.
4. Reinstall idler spring onto traction drive idler arm and
ensure traction drive belt is aligned in all pulleys.
5. Reinstall attachment drive idler assembly. See Install
Attachment Drive Idler Assembly on page 17.
EN – 16
Figure 26
Figure 27