Ariens Sno-Thro Deluxe Series Service Manual page 37

See Figure 77.
10. Reinstall attachment drive belts onto attachment
sheave.
To assist belt installation, slowly pull recoil starter handle
while gently guiding belts into attachment sheave.
11. Reinstall belt finger and secure with original flat steel
washers, locking washers and hex bolts as shown in
Figure 7.
Figure 77
See Figure 78.
12. Check belt finger clearance:
• Engage attachment clutch lever and ensure belt
finger located opposite belt idler is less than 3.2 mm
(1/8") from belt, but not touching the belt.
• If needed, adjust clearance by loosening hex bolts,
repositioning belt finger, and tightening bolts.
1
1. Belt Finger
2. Attachment Drive Belts
13. Reinstall belt cover and secure left side to frame with
one tapping screw. Position right side of belt cover
under tapping screw and tighten.
14. Reinstall chute deflector cable into J-clamp. Bend
clamp slightly to secure cable in clamp.
15. Reconnect spark plug wire and fill fuel tank.
EN – 35
Measure
Here
Figure 78
2