Axle Bushing Replacement; Remove Left Axle Bushing; Install Left Axle Bushing - Ariens Sno-Thro Deluxe Series Service Manual

See Figure 89.
6. Rotate cam so flat edge is positioned upward and
secure with spring clip.
7. Reconnect spring to interlock bracket.
Models 921045, 921046, 921048
Models 921047, 921049, 921323, 921324
8. Check dual-handle interlock function. Refer to
Operator's Manual for test procedure.
IMPORTANT: If dual-handle interlock continues to
malfunction, see your Ariens dealer.
Figure 89

AXLE BUSHING REPLACEMENT

Remove Left Axle Bushing

IMPORTANT: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Ensure unit is secure and will not tip.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Place unit in service position and remove bottom
cover. See Service Position on page 7 and Bottom
Cover Removal on page 12.
4. Remove snap clip from left axle end and remove
wheel.
See Figure 90.
5. Remove axle key and flat steel washer from axle. Take
care to not lose axle key.
6. Remove hardware securing axle bushing to frame and
remove bushing.

Install Left Axle Bushing

1. Install bushing onto axle and secure to frame with
three tapping screws from inside frame.
2. Reinstall flat steel washer.
3. Reinstall bottom cover and secure with two tapping
screws and four hex bolts.
4. Ensure that axle key is in position and reinstall wheel.
Secure with snap clip.
5. Return unit to operating position.
6. Reconnect spark plug wire and fill fuel tank.
EN – 41
Figure 90