Ariens Sno-Thro Deluxe Series Service Manual page 10

See Figure 4.
6. Remove hairpin, sleeve bushing and cable eyelet from
deflector arm under control panel.
7. Using pliers, compress cable anchor tabs and remove
anchor from deflector bracket.
IMPORTANT: Reinstall sleeve bushing and hairpin so parts
are not misplaced.
1
1. Cable Anchor
2. Deflector Arm
3. Deflector Bracket
2
3
Figure 4
8. Remove chute deflector cable from J-clamp on engine
mount. See Figure 5.
See Figure 6.
9. Fully loosen tapping screw securing left side of belt
cover to frame. Tapping screw stays attached to belt
cover.
10. Loosen, but DO NOT remove tapping screw securing
right side of belt cover to frame and remove belt cover.
EN – 8
Figure 5
Figure 6