Notes On Emc - Atmos i View COLPO Operating Instructions Manual

11.0 Notes on EMC

) Medical electrical equipment is subject to special precautions with regard to EMC and must be installed according to the
following EMC notes.
Guidance and manufacturer's declaration – ambient conditions
The ATMOS i View COLPO is suitable for use in the following environments:
• In fields of home health care in any buildings, outdoor areas, and means of transport.
• In professional healthcare facilities such as medical practices, hospitals/clinics, first-aid facilities, and operating theatres/rooms.
The following environments are not suitable:
• Special environments such as factory or military facilities and medical areas near HF surgical devices, short-wave therapy equip-
ment, or within an HF-shielded room of a magnetic resonance imaging system.
The customer or user of the ATMOS i View COLPO must ensure that the device is used in a prescribed environment.
Guidance and manufacturer's declaration – key features
) Please note the Technical Data in these instructions. The essential features are fully usable even in the presence of electromag-
netic disturbances.
Guidance and manufacturer's declaration – removable components that can be replaced by the operator
The ATMOS i View COLPO has the following removable components that can be replaced by the operator:
Type
Power cable
Guidance and manufacturer's declaration – warnings
WARNING
The use of electrical components and accessories other than those specified or provided by the manufacturer may cause increased
electromagnetic interference or reduced immunity to electromagnetic interference and result in faulty operation of the device.
WARNING
Portable RF communications equipment (e.g. radios, antenna cables) should be used no closer than 30 cm* to any part of the
ATMOS i View COLPO, including cables, specified by the manufacturer. Otherwise, degradation of the performance of this equip-
ment could result.
) *The distance may be reduced at higher immunity test levels.
WARNING
Avoid placing the device on top of or next to another device. This could result in faulty operation. If such placement cannot be
avoided, the proper functioning of the device must be monitored regularly. If possible, please switch off any nearby devices that are
not in use.
REF Max. cable length
507.0859.0 3.0 m
29