Advertisement
Saber Spot WW
Universal DMX Control:
versal DMX-512 controller to control the colors, master dimmer and
strobe. A DMX controller allows you to create unique programs tai-
lored to your individual needs.
1. The Saber Spot WW has 3 DMX channel modes. See pages
17-18 for detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 7-9 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 9 to select your DMX channel
mode and set your desired DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
This mode allows either a single unit or several units
Show Mode:
linked together to run a built-in program.
1. Press the MENU button until "Look" is displayed, and press
ENTER.
2. Press the UP or DOWN buttons to find your desired show.
ADJ Products, LLC - www.adj.com - Saber Spot WW Instruction Manual Page 14
Operation
This function allows you to use a uni-
Saber Spot WW
Primary-Secondary Operation
link up to 16 units together and operate without a controller. In a
Primary-Secondary set up, one unit will act as the controlling unit and
the others will react to the controlling units programs. Any unit can
act as a Primary or as a Secondary.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (primary) will use the
female XLR connector only - The last unit in the chain will use the
male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. On the Primary unit find your desired operating mode.
3. On the Secondary units press the MENU button until
"Secondary" is displayed.
4. The Secondary units will now follow the Primary unit.
Saber Spot WW
The Saber Spot WW Plus comes with 2 frost filters. Install the filter in
front of the lens and put the inlcuded retainer ring top to hold the lens
in place.
ADJ Products, LLC - www.adj.com - Saber Spot WW Instruction Manual Page 15
Primary-Secondary Set Up
This function will allow you to
Installing the Frost Lens
Advertisement
