Primary-Secondary Configuration - ADJ 15 HEX BAR IP User Manual

This function will allows you to link units together to run in a Primary-Secondary set-up, in which one
unit will act as the controlling unit and the others will react to the controlling unit's built-in programs.
Any unit can act as a Primary or as a Secondary, but only one unit can be programmed to act as the
"Primary."
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connectors on the rear panel of each unit. Use standard XLR
data cables to link your units together. Remember that the male XLR connector is the input, and
the female XLR connector is the output. The first unit in the chain (primary) will use the female
XLR connector only, and the last unit in the chain will use the male XLR connector only.
2. Connect the first "Secondary" unit to the "Primary."
3. "Primary" Unit: Activate the "Primary" setting located in the "PERSNLTY" menu.
4. "Secondary" Unit(s): Activate the "Secondry" setting located in the "PERSNLTY" menu.
5. Set the "Primary" unit to your desired mode of operation.
6. The Secondary unit(s) will now follow the Primary unit.

PRIMARY-SECONDARY CONFIGURATION

27