Isdn-Bri Programming; Brt Assignment - NEC Neax 2000 IVS2 Manual

ISDN-BRI PROGRAMMING

BRT Assignment

START
Assign an AP number to the BRT card.
CM05
The AP number must match the SENS
switch setting on the BRT card.
Assign the ISDN Protocol Type for DCH
CMAA
circuit on the BRT card.
Assign ISDN trunk number to each
CM07
channel number of BRT.
NOTE: Be sure to assign the trunk
numbers to all circuits (00-03) of
the 2BRTC card, even if only one
PCM digital line is accommodated
to the card.
Set make-busy to the unused
trunk numbers by CME5 Y=1, 2nd
data=0.
A
2
NEAX2000 IVS ISDN System Manual
ND-70919 (E), Issue 1.0
DESCRIPTION
INITIAL
DTI INITIAL
INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
Y=0
•
(1) 04-15, 20-31: AP No.
(2) 10: BRT card
YY=06
•
(1) 04-15, 20-31: AP No. of BRT assigned
(2) ISDN Protocol Type
17 : Australia
18 : New Zealand
20 : AT&T (#4, #5 ESS)
21 : NTI (DMS 100, 250)
22 : Australia ETSI
24 : ETSI Standard (Brazil, Columbia,
Indonesia)
25 : ITU-T Standard (Thailand)
27 : USA NI-1
28 : USA NI-2
63 : Not used
• YY=02
(1) XX ZZ
XX: AP No. assigned by CM05
ZZ : Channel No. (00/01: BRTA)
(2) D000-D255: Trunk No.
Trunk No. already
assigned by CM10 cannot
to be used.
ISDN-BRI Programming
DATA
by CM05
(00-03: 2BRTC)
Page 75