NEC Neax 2000 IVS2 Manual page 91

CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
• When providing Tandem Connection (COT/ODT/LDT/DTI to ISDN, ISDN to COT/ODT/LDT/
DTI), do the following programming:
F
Specify whether the busy tone is sent to a
CM08
calling party of ISDN when a called party
is busy in the tandem connection (ISDN to
COT).
Specify the combination of trunk routes
CM36
allowing the tandem connection.
Specify the timing start when making an
CM41
ISDN call from a station (PB/DP telephone
term
D ) or Attendant Console for the
Tandem Connection.
NOTE 1: By using CM41 Y=0>57, an ISDN call is available even if "#" is not dialed.
NOTE 2: CM41 Y=0>57 is effective for dialing a called number. When dialing a called party
G
Page 80
DESCRIPTION
subaddress, this command is not effective.
DATA
(1) 407
(2) 0 : Available (BT)
1 : Not available (RBT)
Y=0
•
(1) XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ : 00-63: Outgoing Trunk Route
(2) 0 : Allowed
1 : Restricted
• Y=0
(1) 57
(2) 03-14: 3 sec.-14 sec.
If no data is set, the timing start is not
effective.
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0