NEC Neax 2000 IVS2 Manual page 77

CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-PRI Programming
A
Assign the necessary functions to the DTI/
CMAA
PRT card. CMAA YY=00/01/02 assign-
ment is required only for 24DTI/PRT.
After entering the data, set the MB switch
on the DTI/PRT card to UP , and then to
DOWN, for DTI/PRT initialization.
NOTE: The following table shows the
relationship between CMAA
YY=01 and YY=02.
CMAA YY=01
(FRAME CON-
FIGURATION)
24-Multi Frame
[1]
12-Multi Frame
[0]
[ ]: Indicates 2nd data
Assign a trunk route number to each ISDN
CM30
trunk used for voice channel and also to
signaling channel. The DTI route must be
separated from any analog trunk route.
Assign the trunk route data to each ISDN
incoming trunk used for Voice channel
only.
B
Page 66
DESCRIPTION
DTI INITIAL
CMAA YY=02
(ZERO CODE
SIGNALING
SUPPRES-
SION)
B8ZS
Not available [1] Transparent
Available [0] B7
DATA
YY=00 Data Mode
•
(1) 04-15, 20-31: AP No. assigned by
CM05
(2) 0: Based on AT&T Spec.
YY=01 Frame Configuration
•
(1) 04-15, 20-31: AP No. assigned by
CM05
(2) 0 : 12-Multi Frame
1 : 24-Multi Frame
• YY=02 Zero Code Suppression
(1) 04-15, 20-31: AP No. assigned by
CM05
(2) 0 : Available
1 : Not available
YY=03
•
(1) 04-15, 20-31: AP No. assigned by
CM05
(2) 7 : Associated Channel
Interoffice Signaling
• YY=00
(1) 000-255: Trunk No. assigned by CM07
YY=01
(2) 00-63: Trunk Route No.
• YY=02 Day Mode
• YY=03 Night Mode
• YY=40 Mode A
• YY=41 Mode B
(1) 000-255: Trunk No. assigned by CM07
YY=01
(2) 02: Trunk Line Appearance
03: Trunk Line Appearance + TAS
04: Direct-In Termination
09: Automated Attendant
14: Termination to Attendant console
16: Remote Access to System (DISA)
18: ISDN Indial
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0