NEC Neax 2000 IVS2 Manual page 82

• When providing Tandem Connection (ODT/DTI to ISDN, ISDN to ODT/DTI), do the following
programming:
F
Specify the combination of trunk routes
CM36
allowing the tandem connection.
Specify the timing start when making an
CM41
ISDN call from a station (PB/DP
telephone/D
the Tandem Connection.
NOTE 1: By using CM41 Y=0>57, an ISDN call is available even if "#" is not dialed.
NOTE 2: CM41 Y=0>57 is effective for dialing a called number. When dialing a called party
G
2
NEAX2000 IVS ISDN System Manual
ND-70919 (E), Issue 1.0
DESCRIPTION
term
) or Attendant Console for
subaddress, this command is not effective.
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=0
(1) XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ : 00-63: Outgoing Trunk Route
(2) 0 : Allowed
1 : Restricted
• Y=0
(1) 57
(2) 03-14: 3 sec.-14 sec.
If no data is set, the timing start is not
effective.
ISDN-PRI Programming
DATA
Page 71