Commissioning
Configuring controller modules (if installed)
Configuration, modules 2/2
Controller module 1
Controller module 2
Fig. 16
Configuring default settings
The display shows the following screen:
Extended settings
Configuration
Settings
CAN modules
Default display
Settings
Actuator test
General
Fig. 17
Select "Default display settings".
Setting wood boiler
Wood boiler
Recognise
No wood boiler
connected
Fig. 18
Example: With connected Vitoligno 250-S
The Vitotrol 350 automatically recognises the connec-
ted boiler. The display shows the boiler.
Note
A field with a bright background is already enabled.
14
OK
Configuration
Regulated circuits
Change password
Found the following boiler:
VL250S
OK
(cont.)
Press "OK" to confirm
1. If the boiler is not recognised: Check the connection
and routing of the CAN BUS.
2. If the Vitotrol 350 is used without a boiler: Select
"No wood boiler connected".
3. Press "OK" to confirm
Reg circuits on wood boiler
The following reg circuits were found on boiler:
Regulated circuit 1 - Heating - Mixer module 1 - no RC
Regulated circuit 2 - Heating - Mixer module 2 - no RC
Regulated circuit 3 - DHW - Mixer module 3
Manual
configuration
Fig. 19
The display shows an overview of the set regulated cir-
cuits.
Press "OK" to confirm
Select default display
Boiler
Regulated circuit 1 Regulated circuit 1
Fig. 20
OK
Heating