Viessmann Vitotrol 300-B Installation And Service Instructions For Contractors
Remote control for heat pump control unit vitotronic 200, type wo1c
Hide thumbs
Also See for Vitotrol 300-B:
Table of Contents
Related Manuals for Viessmann Vitotrol 300-B
Summary of Contents for Viessmann Vitotrol 300-B
- Page 1 VIESMANN Installation and service instructions for contractors Vitotrol 300-B Remote control for heat pump control unit Vitotronic 200, type WO1C For applicability, see the last page VITOTROL 300-B Please keep safe. 5465 115 GB 6/2016...
- Page 2 ■ installer or a qualified person authorised by the For replacement, use only spare parts supplied installer. or approved by Viessmann. Regulations to be observed National installation regulations ■ Statutory regulations for the prevention of accidents ■...
-
Page 3: Table Of Contents
Installation sequence Vitotrol 300-B installation ............... Vitotrol 300-B connection ............... Connecting several remote controls ............Installing and removing the programming unit ........Commissioning Configuring the Vitotrol 300-B ..............Message displays ........................ Parts lists Ordering parts ..................11 Vitotrol 300-B ..................12 Specification ........................ -
Page 4: Information Symbols
Product information Up to 3 heating circuits and a separate cooling circuit If a mechanical ventilation system is integrated into the can be operated with one Vitotrol 300-B. heating system, the Vitotrol 300-B also controls the central ventilation unit. -
Page 5: Preparing For Installation
Do not install additional control devices in this room. If Note radiators are equipped with thermostatic valves, If the Vitotrol 300-B cannot be installed in a suitable always open these fully. location, connect the separate room temperature sen- sor, part no. 7438 537. -
Page 6: Installation Sequence Vitotrol 300-B Installation
Vitotrol 300-B connection 2-core cable with a cross-section of min. 0.75 mm; Note cores may be interchanged Never route the cable to the Vitotrol 300-B immediately Max. cable length 50 m next to 230/400 V cables. Fig. 2 Vitotrol 300-B... -
Page 7: Connecting Several Remote Controls
Installation sequence Connecting several remote controls Up to 3 Vitotrol 300-B can be connected to the Vitotronic control unit. Vitotrol 200 and Vitotrol 300-B can be jointly connec- ted to the Vitotronic control unit. Version 1 Version 2 15 m... -
Page 8: Commissioning Configuring The Vitotrol 300-B
ID. If, for example, a Vitotrol 300-A was connected during the replacement of a Vitotrol 300-B, the progress bar on the Vitotrol 300-A will run con- stantly. When the progress bar disappears, the configura- tion is complete. -
Page 9: Message Displays
Message displays Message displays When there is a message, the associated message OK to display the message text with message code. symbol flashes on the display. Explanation of messages Display Meaning Fault " " The system is no longer in standard mode; the fault must be corrected as ■... - Page 10 Message displays Message displays (cont.)
-
Page 11: Parts Lists Ordering Parts
Parts lists Ordering parts The following details are required when ordering parts: ■ Serial no. (see type plate ■ Position number of the part (from this parts list) -
Page 12: Vitotrol 300-B
Parts lists Vitotrol 300-B 0001 0003 0002 0004 0005 0006 Fig. 5... - Page 13 Parts lists Vitotrol 300-B (cont.) Pos. Part 0001 Programming unit 0002 Wall mounting base 0003 Cover, wall mounting base 0004 Fixing materials and plugs 0005 Installation and service instructions 0006 Operating instructions...
-
Page 14: Specification
Specification Specification Power supply Via KM-BUS Power consumption 0.5 W Protection class IP rating IP 30 Permissible ambient temperature Operation 0 to +40 °C ■ Storage and transport 20 to +65 °C − ■ Setting range for set room temperature 10 to 30 °C... -
Page 15: Certificates
Certificates Declaration of conformity Vitotrol 300-B We, Viessmann Werke GmbH & Co. KG, D-35107 Allendorf, declare as sole responsible body that the named product complies with the provisions of the following directives and regulations: 2011/65/EU RoHS II 2014/35/EU Low Voltage Directive... -
Page 16: Keyword Index
Keyword index Calling up acknowledged messages......9 Parts list..............11 Commissioning.............8 Product information............4 Connection – Several Vitotrol 300-B..........7 Remote control – Fitting................ 7 Declaration of Conformity...........15 – Removing..............7 Room temperature hook-up......... 5 Fault message..............9 Specification...............14 Information..............4 Installation..............6 Vitotrol 300-B Installation location............5...