System Version With Controller Module; Configuring Controller Modules (If Installed) - Viessmann Vitotrol 350 Installation And Service Instructions Manual

Defining CAN modules
1. Press "OK" as confirmation or wait a few seconds.

System version with controller module

Continue with instructions from chapter "Configuring
controller modules (if installed)", see page 13

Configuring controller modules (if installed)

Up to 5 controller modules can be connected to each
Vitotrol 350.
Configuration, modules 2/2
Controller module 1
Controller module 2
Fig. 12
Tap on the field of the required controller module.
Configuration, reg circuits 1/2 controller module 1
Regulated circuit 1 HC 1
Regulated circuit 2 HC 2
Regulated circuit 3 DHW 1
Regulated circuit 4 Local htg network supply Not assigned
Fig. 13
Tap on the field of the required regulated circuit.
(cont.)
OK
Not assigned
Not assigned
Not assigned
OK
2. Continue with instructions from chapter "Configur-
ing default settings", see page 14
Configuration, reg circuits 2/2 HC1
HC 1
Heating
assembly
not
assigned
Fig. 14
Note
The regulated circuit can be renamed.
1. Assign one of the assemblies displayed to the regu-
lated circuit. For this, tap on "Heating group",
"DHW group", "Not assigned", or "Local heating
network group".
2. Press "OK" to confirm
Configuration, reg circuits 1/2 controller module 1
Regulated circuit 1: Regulated circuit 1
Regulated circuit 2: Regulated circuit 2
Regulated circuit 3: Regulated circuit 3
Regulated circuit 4: Regulated circuit 4
Fig. 15
1. Carry out the above steps for all required regulated
circuits.
2. Press "OK" to confirm
Commissioning
DHW
assembly
Local heating network supply
assembly
OK
Heating
DHW
Not assigned
Not assigned
OK
13