Vega MINITRAC 31 Operating Instructions Manual page 42

6 Set up with the display and adjustment module
42
Value pairs that are not yet complete, e.g. due to a missing density
determination, can be edited later with the function " Setup - Lineari-
zation" under the item " Change/Edit".
A maximum of 32 linearisation points is possible.
Note:
If you cannot change the medium during the adjustment process, it
is possible to carry out the linearization with only one point. However,
you should enter further linearization points later, if possible.
•
Show diagram
This menu item is only available if a linearization was already carried
out.
•
Show table
In this menu item you can show the individual value pairs of the
linearization.
•
Linearization - Delete
You can also delete individual linearization points. Enter the number
of the point you want to delete.
•
Linearization - Modify
You can also modify individual linearization points.
After editing, you have to activate the complete value pair so that the
linearization point will be effective.
MINITRAC 31 • Foundation Fieldbus