Vega MINITRAC 31 Operating Instructions Manual page 57

Menu
Setup
Display
Copy instrument settings
Info
MINITRAC 31 • Foundation Fieldbus
Menu item
Measurement loop name
Isotope
Application
Adjustment mode
Adjustment - uncovered
Adjustment - covered
Delta I
Background radiation
Temperature unit
Adjustment mode
Adjustment uncovered
Delta I
Mode - Relay
Lock adjustment
Language
Displayed value
Display unit
With this function
•
Load parameter adjustment data from the sensor into the display
and adjustment module
•
Write parameter adjustment data from the display and adjustment
module into the sensor
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
a power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible sensor exchange.
Note:
Before the data are copied into the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal
is triggered. When data are being written into the sensor, the display
shows which instrument type the data originate from and which TAG
number this sensor had.
6.5.5 Info
In this menu you will find the following menu items:
•
Instrument name - shows instrument name and serial number
6 Set up with the display and adjustment module
Default value
Sensor
Cs-137
Limit level
Single point adjustment
90000 ct/s
9000 ct/s
only with two-point adjustment
90 %
0 ct/s
° C
1-point
900000 ct/s
90 %
Overfill protection
Released
Selected language
Pulse rate
ct/s
57